U-EK230E Motor protection

Thermistor Motor protection ATEX approved

Art. no.: 30199

Thermistor motor protection

Monitoring device (PTC thermistor tripping device) with potential-free signal contact (at AC15: 250VAC & 3A)(e.g. for connection to a system controller or a frequency converter) to protect all motors with integrated PTC thermistors.

The U-EK 230E is a thermistor motor protection device which is intended for use in conjunction with a contactor for the protection of the Ex fans, it can also be used for fans with built-in thermistor. This is an electronic unit designed for snap fitting on to a 35 mm instrument rail. Fan motors have six series-connected thermistors, two per phase winding, whose resistance is determined by the motor temperature. When the motor temperature exceeds the permitted limit, the resistance rises sharply and the motor protector is triggered.

When the motor protector has been triggered, the warning light marked "Fault" is illuminated. The device is reset manually, either by pressing the "Reset" button, or by interrupting the voltage supply to the motor protector (stopping supply to A2) for approximately 10 seconds.

If a five-step transformer is used for regulating EX fans, the U-EK 230E should be connected to the transformer.

A casing is available as an accessory.

Do not place the U-EK 230E in the EX zone!

Technical parameters

Nominal data
Voltage (nominal) 230 V
Frequency 50 Hz
Protection/Classification
Enclosure class IP20
Ambient and duct temperature
Permitted ambient temperature -20 to 50 °C
Switching capacity 250V AC / 3A
Dimensions and weights
Depth 58 mm
Height 116 mm
Width 35 mm
Weight 0.15 kg
U-EK plastic housing IP65 - Systemair
Art. no.: 298149
U-EK plastic housing IP65

Plastic housing IP65 for motor protection U-EK230E

.