Centrifugal roof fan, 120°C continuous, vertical discharge
Art. no.: 95323
Octagonal casing is manufactured from seawater resistant aluminium. The base frame consists of hot-dip galvanised steel. Impeller with backward-curved blades is manufactured from steel and galvanized. For C4 (and up) corrosion category additional surface protection of exposed parts is recommended.
Motor cooling with fresh air via air duct. The motor protection is provided by customers. Service switch serial on cooling duct. For speed control of single speed motors use combination of frequency inverter and appropriate filter to motor side (sine or du/dt), respectively observe instructions. At frequency controlled units additional EMC protection could be needed (see also items with EMC protection - marked EMC, other are available on request).
Product | ||
---|---|---|
Trade name | Systemair | |
Product name | DVV 800D6-XL/120°C |
Ecodesign | ||
---|---|---|
ErP compliance | 2016 | |
Unit category | NRVU | |
Drive | External MSD or VSD | |
Unit type | UVU | |
Heat recovery type | None | |
Temperature ratio (UVU) | Not applicable | |
qv nom | 4.861 | m³/s |
P nom | 5.595 | kW |
Ps nom | 590 | Pa |
Fan efficiency | 51.3 | % |
External Leakage | 0 | % |
Sound power level LWA | 93 | dB(A) |
Nominal data | ||
---|---|---|
Voltage (nominal) | 400 | V |
Frequency | 50 | Hz |
Phase(s) | 3~ | |
Motor circuit connection | D | |
Input power | 5,595 | W |
Nominal power at shaft (P2) | 5.5 | kW |
Starting current | 66 | A |
Starting current (Y - D starting) | 22 | A |
Input current | 11.2 | A |
Impeller speed | 955 | rpm |
Air flow | max 7,361 | L/s |
Temperature of transported air | max 120 | °C |
Sound data | ||
---|---|---|
Sound pressure level at 10m (free field) | 64 | dB(A) |
Sound pressure level at 4m (free field) | 71 | dB(A) |
Protection/Classification | ||
---|---|---|
Enclosure class, motor | IP55 | |
Insulation class | F |
Data according to ErP | ||
---|---|---|
ErP ready | ErP 2016; Not ErP relevant |
Dimensions and weights | ||
---|---|---|
Duct dimension; Circular, inlet | 800 | mm |
Duct dimension; Circular, outlet | 800 | mm |
Weight | 225 | kg |
Others | ||
---|---|---|
Duct connection type | Circular | |
Motor type | AC |
Lock the service switch in position ON to prevent unintended switch OFF! |
Lock is not in scope of fan. |
Upper connection: starting in star (not for continuous operation!) |
Lower connection: operation in delta |
Mid-frequency band, Hz | ||||||||||
800D6-XL |
Hz |
Tot |
63 |
125 |
250 |
500 |
1k |
2k |
4k |
8k |
LwA Inlet |
dB(A) |
91 |
67 |
78 |
80 |
87 |
82 |
81 |
77 |
64 |
LwA Surrounding |
dB(A) |
93 |
69 |
80 |
82 |
89 |
84 |
83 |
79 |
66 |
Measuring point: qv = 6 m3/s, ps = 370Pa |
DVV 800-LOW |
Roof fan, vertical blowing. The DVV-XS...XP/120 radial fans are intended for the normal daily ventilation, temperature of air up to 120°C. The base frame with inlet cone is made of hot-dip galvanized steel sheet. The outer octagonal casing from seawater-resistant aluminium. Bird protection grill inside casing. The air stream is carried out through annular space between the casing and the motor housing. The fan has a backward curved radial impeller made of steel and galvanized. With hub and secured bolted joint directly assembled on the motor shaft. Dynamically balanced according to ISO 1940 T1 quality class G6,3. Driven by an IEC IE2 high efficiency motor, single speed. PTC thermal protection serial built-in electric motor. Cooling of the motor with ambient air through an air duct in underpressure system. The motor protection is provided by customers. Connection the fan to the mains in service switch outside on the casing. For speed control use combination of frequency inverter and appropriate filter to motor side (sine or du/dt), respectively observe instructions. EMC protection (for frequency control, if needed) on request, serial not EMC protected cables, cable glands and service switches are used. Flange connection according to EUROVENT. An additional sound attenuator HSDV (preferable factory mounted) is available as accessory (the marking of the fan with silencer is DVVI).
Roof cowl - for DVV XS/XL 6, 8 pol and 6-8 pole, XS: 4 pole